HP MC68360 User Manual page 328

Chapter 11: Emulator/Analyzer Interface Commands
copy
pod_command This allows you to copy the most recent commands sent to the HP 64700 Series
emulator/analyzer.
printer This option specifies your system printer as the destination device for the copy
command. Before you can specify the printer as the destination device, you must
define PRINTER as a shell variable. For example, you could enter the text shown
below after the "$" symbol:
$ PRINTER=lp
$ export PRINTER
If you don't want the print message to overwrite the command line, execute:
$ set PRINTER = "lp -s"
registers
Copies a list of the contents of the emulation processor registers to the selected
destination.
software Copies a list of the current software breakpoints to a selected destination.
_breakpoints
status
Copies emulation and analysis status information.
to
This allows you to specify a destination for the copied information.
trace Copies the current trace listing to the selected destination.
! An exclamation point specifies the delimiter for UNIX commands. An
exclamation point must precede all UNIX commands. A trailing exclamation point
should be used if you want to return to the command line and specify noheader.
Otherwise, the trailing exclamation point is optional. If an exclamation point is
part of the UNIX command, a backslash (\) must precede the exclamation point.
Examples
See the following pages on various copy syntax diagrams.
See Also See the following pages on various copy syntax diagrams.
308