HP MC68360 User Manual page 432

Chapter 12: Emulator Error Messages
Conflicting disassembler option: <option> (Error 1000)
Conflicting disassembler option: <option> (Error 1000)
Cause: This error occurs when you attempt to specify inverse assembly options that
are not allowed with each other.
Action: Do not use conflicting inverse assembly options in the same trace list
command.
Copy memory aborted; next destination: <address> (Error 752)
Cause: One of these messages is displayed if a break occurs during processing of
the copy memory, or modify memory commands. The break could result from
any of the break conditions or could have resulted from a <CTRL> c break.
Action: Retry the operation. If breaks are occurring continuously, you may wish to
disable some of the break conditions.
Copy target image not supportee (Error 161)
Cause: The cim (copy target image memory) command cannot be used in this
emulator. Normally, the cim command would be used to copy a target system
memory range to emulation memory so you could set breakpoints or patch code.
Action: To do this without the cim command, save the target system memory range
to an absolute file using the copy command. Then remap the target memory range
to emulation memory, and load the absolute file into emulation memory using the
load command. Refer to Chapter 6, "Using the Emulator", for information on
saving and loading absolute files.
Count out of bounds: <number> (Error 318)
Cause: You specified an occurrence count less than 1 or greater than 65535 for a
trace trigger or trace find sequence command.
Action: Reenter the command, specifying a count value from 1 to 65535.
412