Table of Contents
Advertisement
Examples
Display the trace list without instruction disassembly and with status information in
binary format:
Choose Trace→Display Options... and in the dialog box, select Data Format
Absolute. Select Status Format Binary. Then click the OK or Apply pushbutton.
Or, using the command line, enter:
display trace absolute status binary
Display the trace list without instruction disassembly and with status information in
hexadecimal format, make appropriate entries in the Trace→Display Options...
dialog box, or enter the following command:
display trace absolute status hex
Display the trace list without instruction disassembly and with status information in
mnemonic format, make appropriate entries in the Trace→Display Options...
dialog box, or enter the following command:
display trace absolute status mnemonic
To display symbols in the trace list
• Choose Settings→Source/Symbol Modes→Symbols, or choose
Settings→Display Modes ..., and in the dialog box, click on Symbolic Addresses.
In the Field Widths area of the dialog box, you can select the widths of the Label
Field and Symbols in Mnemonic Field to control the display space allocated to the
symbols. To select symbol types, use the command line, described below.
• Using the command line, enter commands as follows:
•
set symbols on
To display symbols in the trace list, enter:
Chapter 7: Using the Emulation-Bus Analyzer
Displaying the Trace List
195
Advertisement
Table of Contents
