Table of Contents
Advertisement
The Getting Started Tutorial
This tutorial gives you step-by-step instructions on how to perform a few basic
tasks using the emulator/analyzer interface. The tutorial examples presented in this
chapter make the following assumptions:
•
The HP 64780 emulator and 80-channel analyzer are installed into the
HP 64700 Card Cage, the HP 64700 is connected to the host computer, and the
Graphical User Interface software has been installed as outlined in Chapter 14,
"Installation."
•
The emulator is operating out-of-circuit (that is, plugged into the demo board,
not your target system).
•
You have selected the appropriate clock module and installed it in the
emulator probe according to the instructions in the MC68360
Emulator/Analyzer (HP 64780A) Installation/Service/Terminal Interface
manual that was supplied with your emulator hardware.
The Demonstration Program
The demonstration program used in this chapter is a simple environmental control
system. The program controls the temperature and humidity of a room requiring
accurate environmental control.
Depending of the version of the demo program you are using and of your compiler,
line numbers and memory locations may not match those shown in this manual.
Chapter 1: Getting Started
11
Advertisement
Table of Contents
