Table of Contents
Advertisement
The default STATE expression type is address.
The parameters are as follows:
address
This specifies that the expression following is an address value. This is the default,
and is therefore not required on the command line when specifying an address
expression.
and
This lets you specify a combination of status and expression values when status is
specified in the state specification.
data
The value following this softkey is searched for on the lines that monitor the
emulation processor's data bus.
--EXPR--
An expression is a combination of numeric values, symbols, operators, and
parentheses, specifying an address, data, status, or executed address value. See the
EXPR syntax diagram.
<external_label>
This represents a defined external analyzer label.
not
This specifies that the analyzer will search for the logical "not" of a specified state
(this includes any address that is not in the specified state).
status
The value following this softkey is searched for on the lines that monitor other
emulation processor signals.
<STATUS>
This prompts you to enter a status value in the command line. Status values can be
entered from softkeys or typed into the keyboard. Numeric values may be entered
using symbols, operators, and parentheses to specify a status value. See the EXPR
syntax diagram.
Examples
trace before status write <RETURN>
trace about address 1000H status write <RETURN>
See the trace command examples.
See Also
The trace command and the QUALIFIER syntax description.
Chapter 11: Emulator/Analyzer Interface Commands
STATE
379
Advertisement
Table of Contents
