Table of Contents
Advertisement
Example
Recall the last trace command with Trace→Trace Spec..., or by entering:
trace modify_command
Then edit the trace command as you desire.
To repeat the previous trace command
• Choose Trace→Again.
• To continually repeat the last trace, choose Trace→Repetitively.
• Using the command line, repeat the previous trace command (including its
complete trace specification) by entering:
trace again
The trace again command is most useful when you want to repeat a measurement
with the same trace specification. It saves you the trouble of reentering the
complete trace command specification.
The "repetitively" choice continually repeats the last trace command. Successive
traces begin as soon as the results from the just-completed trace are displayed.
Also, this command is useful when you load a trace specification from a file. (See
"To load a trace specification" in this chapter.)
Chapter 7: Using the Emulation-Bus Analyzer
Making Complex Trace Measurements
221
Advertisement
Table of Contents
