Table of Contents
Advertisement
Chapter 11: Emulator/Analyzer Interface Commands
run
absolute file containing a transfer address has just been loaded, execution starts at
that address.
The parameters are as follows:
address
Specifies an address for a temporary register breakpoint that will be programmed
into one of the processor's two breakpoint registers. Up to two addresses may be
specified.
--EXPR--
An expression is a combination of numeric values, symbols, operators, and
parentheses, specifying a memory address. See the EXPR syntax diagram.
FCODE
The function code used to define the address space being referenced. See the
syntax diagram for FCODE to see a list of the function codes available and for an
explanation of those codes.
from
This specifies the address from which program execution is to begin.
reset
This option resets the processor prior to running.
transfer_address
This represents the starting address of the program loaded into emulation or target
memory. The transfer address is defined in the linker map and is part of the
symbol database associated with the absolute file.
until
Causes a software breakpoint to be set at the specified address before the program
is run.
soft_reset
Causes a soft reset.
Examples
run <RETURN>
run from 810H <RETURN>
run from COLD_START <RETURN>
run from transfer_address until 910H <RETURN>
See Also
The step command.
368
Advertisement
Table of Contents
