If you're using the Softkey Interface from a terminal or terminal emulation
window, you don't get a dialog box from which to choose configuration sections;
however, you have access to the same configuration options through a series of
configuration questions. To access the questions in the "Interactive Measurement
Specification" section, answer "yes" to the "Modify interactive measurement
specification?" question.
This section shows you how to:
•
Drive the emulation analyzer trigger signal to the CMB.
•
Drive the emulation analyzer trigger signal to the BNC connector.
•
Break emulator execution on signal from CMB.
•
Break emulator execution on signal from BNC.
•
Arm the emulation analyzer on signal from CMB.
•
Arm the emulation analyzer on signal from BNC.
Chapter 9: Making Coordinated Measurements
Using Trigger Signals
271