HP MC68360 User Manual page 453

Chapter 12: Emulator Error Messages
Symbol cannot contain wildcard in this context (Error 878)
Symbol cannot contain wildcard in this context (Error 878)
Cause: You tried to enter a global, local, or user symbol name using the wildcard
(*) incorrectly.
Action: When you enter the symbol name again, include the wildcard (*) at the end
of the symbol.
Symbol not found: <symbol> (Error 877)
Cause: This occurs when you try to enter a symbol name that doesn't exist.
Action: Enter a valid symbol name.
Target memory access failed (Error 700)
Cause: The emulator was unable to perform the requested operation on memory
mapped to the target system. This message is displayed in conjunction with other
error messages that further clarify the problem that occurred. In most cases, the
problem results from the emulator's inability to break to the monitor to perform the
operation.
Action: See other error messages in the error log to further understand the cause of
the error.
Target reset and run while in monitor(BDM) (Error 143)
Cause: The emulator had placed the target processor in Background Debug Mode
(BDM), and during execution in BDM, the target system was reset.
Action: Reissue your command after target reset.
Trig1, trig2 delay spec out of bounds: <Entered Numeric Value> (Error 1255)
Cause: The terminal interface tgout (trigger output) command of the deep analyzer
provides a delay feature that allows for driving of the trig1 and/or trig2 signals a
specified number of states after trigger or before trace complete. The delay value
must be in the range 0 through "current analyzer depth - 1". The current analyzer
depth is controlled by the terminal interface command tcf. Note: Use of this delay
feature may cause modification of the current trigger position value.
Action: Correct the delay value in your specification so that it is within the range
of 0 through "current analyzer depth -1".
433