Table of Contents
Advertisement
Chapter 4: Entering Commands
Using the Command Line with the Mouse
To recall commands
1 Click the pushbutton labeled Recall in the Command Line to display the dialog box.
2 Choose a command from the buffer list. (You can also enter a command directly
into the text entry area of the dialog box.)
Because all command entry methods in the interface — pulldown menus, action
keys, and command line entries — are echoed to the command line entry area, the
contents of the Command Recall dialog box is not restricted to just commands
entered directly into the command line entry area.
The Command Recall dialog box contains a list of interface commands executed
during the session as well as any predefined commands present at interface startup.
If you exit the emulation/analysis session with the interface "locked", commands in
the recall buffer are saved and will be present when you restart the interface.
You can predefine entries for the Command Recall dialog box and define the
maximum number of entries by setting X resources (refer to Chapter 10, "Setting X
Resources").
See "To use dialog boxes" for information about using dialog boxes.
To get help about the command line
• To display the help topic explaining the operation of the command line, press the
Help pushbutton located near the bottom-right corner of the Command Line area.
70
Advertisement
Table of Contents
