Step 3: Run From The Transfer Address - HP MC68360 User Manual

Chapter 1: Getting Started

Step 3: Run from the transfer address

Step 3: Run from the transfer address
The transfer address is the entry address defined by the software development tools
and included with the program's symbol information.
• Click on the Run Xfer til () action key.
Or, using the command line, enter:
run from transfer_address until main <RETURN>
Notice the message "Software break: <address>" is displayed on the status line and
that the emulator is "Running in monitor" (you may have to click the select mouse
button to remove temporary messages from the status line). When you run until an
address, a breakpoint is set at the address before the program is run.
Notice the highlighted bar on the screen; it shows the current program counter.
14