Table of Contents
Advertisement
Step 2. Verify the software installation
A number of new filesets were installed on your system during the software
installation process. This and following steps assume that you chose to load the
Graphical User Interface filesets.
You can use this step to further verify that the filesets necessary to successfully
start the Graphical User Interface have been loaded and that customize scripts have
run correctly. Of course, the update process gives you mechanisms for verifying
installation, but these checks can help to double-check the install process.
1 Verify the existence of the HP64_Softkey file in the
/usr/hp64000/lib/X11/app-defaults subdirectory by entering
ls /usr/hp64000/lib/X11/app-defaults/HP64_Softkey at the HP-UX prompt.
Finding this file verifies that you loaded the correct fileset and also verifies that the
customize scripts executed because this file is created from other files during the
customize process.
2 Examine /usr/hp64000/lib/X11/app-defaults/HP64_Softkey near the end of the
file to confirm that there are resources specific to your emulator.
Near the end of the file, there will be resource strings that contain references to
specific emulators. For example, if you installed the Graphical User Interface for
the 68360 emulator, resource name strings will have m68360 embedded in them.
After you have verified the software installation, you must start the X server and an
X window manager (if you are not currently running an X server). If you plan to
run the Motif Window Manager (mwm), or similar window manager, continue with
Step 3a of these instructions. If you plan to run HP VUE, skip to Step 3b of these
instructions.
Chapter 14: Installation
Installing HP 9000 Software
459
Advertisement
Table of Contents
