Table of Contents
Advertisement
Chapter 12: Emulator Error Messages
Analyzer Break (Async_Stat 613)
The emulator/analyzer interface provides feedback to the user through messages
that are displayed on the STATUS line.
The messages in this chapter are listed in alphabetical order.
Some messages have error numbers assigned to them. These error numbers are
shown in parenthesis at the end of the message text in this chapter.
The error log records error messages received during the emulation session. You
may want to display the error log to view the error messages. When several
messages are generated for a single error condition, you will have to view the error
log to see the complete list of messages. Only the last error message in the
sequence will remain in the status line display area.
The error log can hold up to 100 messages. To prevent overrun, the error log
purges the oldest messages to make room for the new ones.
Emulator error messages
Analyzer Break (Async_Stat 613)
Cause: Status message. No action necessary.
Analyzer SIMMs are not all the same size; using smallest size (Status 1002)
Cause: Plug-in SIMMs are used to expand the trace depth to 64k or 256k states in
the deep analyzer. Four SIMMs, all of the same size must be used. If they are not
all the same size, the smallest SIMM size in the set of four will be used for trace
depth.
Action: No action necessary.
Arm term used more than once (Error 1250)
Cause: This error occurs when you attempt to use the "arm" qualifier more than
once in a sequencer branch expression.
Action: Reenter the trace command and specify the "arm" qualifier only once.
404
Advertisement
Table of Contents
