14
Overview
Configuring RIP on the Switch
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Configuring RIP Routing
* Note: To globally enable the Routing Information Protocol (RIP), see
Chapter
12,
The information and procedures provided in this chapter pertain to 50-series
layer 3, and licensed 80-series module configurations only:
This section describes:
Configuring RIP on the Switch
Modifying RIP Interfaces
Creating Trusted RIP Neighbors
Viewing RIP Statistics
Key Chains
NBMA IP Interfaces
For more information about the CLI commands that are mentioned in this
chapter, see Command Reference Guide for the Avaya P580 and P882
Multiservice Switches, Software Version 6.0
You can configure RIP from either the Web Agent or the CLI.
* Note: MD5 authentication in the 5.X versions of switch software is
not compatible with MD5 authentication in earlier versions of
the software.
If you enable MD5 authentication on a switch that is running
5.X software and on a switch that is running 4.X software, the
switches do not exchange routing information.
"Configuring IP
Routing."
14-1