CLI Command
Viewing LGMP Clients Statistics
Web Agent
Procedure
CLI Command
Viewing LGMP Clients per VLAN statistics
Web Agent
Procedure
Document No. 650-100-700, Issue 1
2. Select Enable from the State field pull-down menu, if it is not already
displayed.
3. Select APPLY to complete the operation, or CANCEL to ignore the
operation.
To enable an LGMP client using the CLI, enter the following command
from Configure mode:
(configure)# set lgmp client enable
You can view LGMP clients statistics using either the web agent or the CLI.
To view LGMP Client statistics using the web:
1. Select LGMP Client from the L2 > Intelligent Multicast group on the
Web Agent window. The LGMP Client Configuration dialog box
opens
(Figure
20-14).
2. See
Table 20-11
for an explanation of the LGMP Client Configuration
dialog box parameters
3. Click CLEAR to clear the statistics, or REFRESH to refresh the
contents of the table.
To view the LGMP client statistics using the CLI, enter the following
command from Configure mode:
(configure)# show lgmp client statistics
You can view LGMP clients per VLAN statistics using either the web agent
or the CLI.
To view LGMP client statistics per VLAN using the Web Agent:
1. Select LGMP Client from the L2 > Intelligent Multicast group on the
Web Agent window. The LGMP Client Configuration dialog box
opens
(Figure
20-14).
2. Select the number from the LGMP Clients field. The LGMP Client
Display per VLAN dialog box opens
Managing Intelligent Multicasting
(Figure
20-15).
20-31