Avaya P580 User Manual page 440

Chapter 14
Web Agent
Procedure
14-2
To configure the RIP globally on your switch using the Web Agent:
1. Select Global Configuration from the Routing > IP > RIP group on
the Web Agent window. The RIP Global Configuration dialog box
opens (Figure 14-1).
Figure 14-1. RIP Global Configuration Dialog Box
2. See Table 14-1 to configure the RIP Global Configuration dialog box
parameters:
Table 14-1. RIP Global Configuration Dialog Box Parameters
Parameter Allows you to...
Global RIP Enable or disable the RIP protocol. The default is Enable.
Note:
Update Timer Enter the value (in seconds) that represents the time between
RIP updates on all interfaces. The parameter range setting is
10-50 ms. The default value is 30 ms.
Purge TTL Enter the "garbage-collection" time. Upon expiration of the
time-out, the route is no longer valid, however, it is retained in
(Garbage
the routing table for a short time so that neighbors can be
Collection
notified that the route has been dropped.Global Time To Live
Timer)
(TTL) in seconds that the RIP update persists. The default
value is 120 seconds.The parameter range setting is 1-9999
seconds.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
You must disable the IP Interface before Disabling or
Enabling RIP.
1 of 2