Configuring Rip On The Switch; Overview; Configuring Rip On The Switch Using The Web Agent; Chapter 10 — Configuring The Routing Information Protocol (Rip) - Avaya Cajun P550R User Manual

10

Overview

Configuring RIP on the Switch

Configuring RIP
on the Switch
Using the Web
Agent
Cajun P550/P880/P882 Switch User Guide
Configuring the Routing
Information Protocol (RIP)
* Note: You must globally enable RIP before it can be
configured. To globally enable RIP, refer to "Creating an
IP Interface", and "Configuring Virtual Redundant
Router Protocol (VRRP)", in Chapter 9, "Configuring IP
Routing".
The information and procedures provided in this chapter pertain to
layer 3 module configuration only:
This section describes:
Configuring RIP on the Switch
Modifying RIP Interfaces
Creating Trusted RIP Neighbors
Viewing RIP Statistics
You can configure the RIP from either the web agent or the CLI.
To configure the RIP globally on your switch using the web agent:
1. Select Global Configuration from the Routing > IP > RIP
group on the Web Agent window. The RIP Global
Configuration dialog box opens (Figure 10-1).
10-1