Creating Ipx Sap Filters - Avaya P580 User Manual

Multiservice switches

Hide thumbs Also See for P580:

Table of Contents

Creating IPX SAP Filters

Document No. 650-100-700, Issue 1

Table 18-1. IPX SAP Interface Dialog Box Parameters

Triggered Updates

Get Nearest Server

Reply Delay(msec.)

3. Click APPLY to save your changes, or CANCEL to restore previous

To configure the IPX SAP interfaces using the CLI, enter the following

command from Interface mode:

(config-if <interface-name>):# ipx sap

This section provides the following procedures:

Creating IPX SAP Name Filters

Creating IPX SAP Network Filters

Configuring the IPX SAP Protocol

Allows you to...

Select one of the following from the pull-down menu:

• Disable – To prevent SAP updates from being

immediately transmitted to the network in

response to changes in the network topology

• Enable – To allow SAP updates to be

immediately transmitted to the network in

response to changes in the network topology

Select one of the following from the pull-down menu:

• Disable – To prevent the router from responding

to Get Nearest Server requests received on the

• Enable – To allow the router to respond to Get

Nearest Server requests received on the

interface (default).

Specify the delay (in msecs) to wait before responding

to a Get Nearest Service request received on the

interface.Default is 0.

Select one of the following from the pull-down menu:

• Talk/Listen - Send and receive advertisements

• Talk Only - Send advertisements.

• Listen Only - Receive advertisements.