Avaya P580 User Manual page 510

Chapter 17
17-2
2. See Table 17-1 to modify the IPX RIP Interfaces dialog box
parameters:
Table 17-1. IPX RIP Interfaces Dialog Box Parameters
Parameter
Select
Interface
Network Number
Use Interpacket Gap
Use Max Packet Size
Periodic Update
Interval (sec)
Aging Interval
Multiplier
Triggered Updates
Advertise Default
Route Only
Mode
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Allows you to...
Select a RIP interface to modify.
Note:
This field is displayed in the IPX RIP Interface
dialog box.
Identify the IPX interface associated with the RIP
interface.
Identify the number of the IPX network associated
with the interface.
Select Disable if you do not want RIP updates sent out
over an interface to have an interpacket transmission
delay. The default is Enable.
Enable or disable the transmission size of RIP packets
sent out an interface:
• If enabled, RIP packets can contain the
maximum allowed by the MTU of the RIP
interface.
• If disabled, RIP packets are limited to 50
network entries.
• The default is Disabled
Specify the length of time for the periodic update
interval. The default is 60 sec.
Specify the length of time that information from
received RIP updates are kept as a multiplier of the
Periodic Update Interval. The default is 3.
Select Disable to disallow RIP updates to be
immediately transmitted to the network in response to
changes in the network topology. The default is
Enable.
Select Enable to allow the advertising of the default
network exclusively (subject to a route to the default
network being known to the switch). The default is
Disable.
Select the one of the following modes for the RIP
interface:
• Talk/Listen - Send and receive advertisements.
• Talk Only - Send advertisements.
• Listen Only - Receive advertisements.
The default is Talk/Listen