Avaya P580 User Manual page 379

Document No. 650-100-700, Issue 1
2. Select an interface and perform one of the following:
Click REFRESH to view the latest interface statistics.
—
Click CLEAR All to reset all statistics to zero.
—
Click CLEAR to reset the selected interface.
—
3. See Table 12-20 for an explanation of the DVMRP Interface Statistics
dialog box parameters:
Table 12-20. DVMRP Interface Statistics Parameters
Parameter
DVMRP Interface
Network Address
Address Mask
State
Type
Metric
IGMP Querier on
Interface
Next Probe Message
in (sec)
Unrecognized
Packets Received
Defines the...
IP interface configured with the DVMRP multicast
routing protocol.
IP address of the interface configured with the
DVMRP multicast.
IP subnet mask associated with the interface.
Current status of the interface. Possible status
indications include:
• UP - The interface is active.
• DOWN - The interface is inactive.
Type of interface configured. Possible values include:
• Broadcast - All traffic is forwarded through the
routers. This is not a tunnel and does not require
encapsulation.
• IPIP Tunnel - All multicast traffic (data and
protocol messages) on this interface is
encapsulated in IP unicast packets with the
protocol set to IPIP (IP in IP).
• Non-Encapsulated Tunnel - All multicast data
traffic on this interface is IPIP encapsulated, but
the protocol messages are simple unicast.
Interface cost.
Router is the IGMP querier. The purpose of the IGMP
querier is to periodically poll hosts on your network to
trigger group membership reports.
Time (in seconds) remaining until the next probe
message is sent.
Number of unknown DVMRP messages.
Configuring IP Routing
1 of 2
12-63