Avaya P580 User Manual page 262

Chapter 8
8-50
See Table 8-11 for explanations of the keywords, arguments, and
options in this command.
The CLI displays a confirmation message if you successfully enable
NEDR for a port or range of ports. If no message displays, the port
information was invalid.
* Note: Occasionally, if you enable NEDR on a 10-Gigabit port, the
following error message is displayed:
Set port network-error-detection failed:
<10-Gigabit port number> .
NEDR is successfully enabled regardless of the error message.
Ignore the error message.
3. To verify that NEDR is enabled on a port, enter the following CLI
command:
show port network-error-detection [<mod-port-range>]|
If the port is not listed as enabled for NEDR, reenable NEDR on the
same port or ports again.
Table 8-11. Keywords, Arguments, and Options
Keywords, Arguments
and Options
<mod-port-range>
all
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Explanation
The slot number of the module, and, either port
number, or range of port numbers. Enter the port
Px Py
ranges in the format -
• To specify port 1 on the module in slot 3,
enter 3/1.
• To specify ports 1 through 5 on the module
in slot 3, enter 3/1-5.
Disables NEDR on all ports on all modules in the
switch. all can be used only with off.
Note:
The set port network-error-detection
all action off CLI command does not
turn off NEDR on 10-Gigabit ports. To
turn off network error detection for
specific 10-Gigabit ports, use the set
port network-error-detection
port-range>
action off command.
. For example:
<mod-
1 of 2