Requirements For Ip Routing; Hardware Requirements; Software Requirements; Minimum Configuration Requirements - Avaya P580 User Manual

Multiservice switches

Hide thumbs Also See for P580:

Table of Contents

Requirements for IP Routing

Document No. 650-100-700, Issue 1

To configure your switch as an IP router, you must configure your switch

with the following hardware:

Layer 3 supervisor module

* Note: Licensed layer 3 80-series media modules are recommended for

best routing performance.

To configure your switch as an IP router, with 80-series modules

(Supervisor and Media modules) you must configure your switch with a

minimum of version 5.0 and above.

Your switch must be configured as follows to successfully create IP routing:

VLANs (subnets) have been created to address current or future

network configurations, or if you plan to expand your current

Assign an IP address, and subnet mask to each configured IP

IP unicast forwarding must be globally enabled.

At least one routing protocol (RIPv1,RIP v2, OSPFv2) must be

enabled, if communication between routers is necessary.

Configuring IP Routing