Chapter 12
CLI Commands
12-10
Table 12-1. Add IP Interface Web Page Fields
Parameter
Allows you to...
Multicast
Specify the multicast protocol for the interface. Options
Protocol
include:
* Note: By Default, multicast forwarding is
Proxy ARP
Enable or disable Proxy ARP. The default value is
Disable.
ICMP Redirect
Enable or disable ICMP Redirect (IDRP). The default
value is Enable.
NetBIOS UDP
Enable or disable NetBIOS UDP Rebroadcasts. The
Rebroadcast
default value is Disable.
VRRP
Enable or disable Virtual Redundancy Router Protocol.
The default value is Disable.
BOOTP/DHCP
Enable or disable the BOOTP/DHCP Relay Agent. The
Relay Gateway
default value is Enable.
To create an IP interface, you must use two CLI commands:
1. Create an Interface Name first.
(configure)# interface <interface_name> type <ethernet |
nbma>
Example: (configure)# interface myif type ethernet
2. Assign an IP address to the interface.
(confg-if:myif)# ip address <ip-address> <mask>
Example: (config-if:myif)# ip address 192.168.97.1
255.255.255.0
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
• None (Default)
• DVMRP
• IGMP
disabled. To enable multicast
forwarding go to the IP Global
Configuration page.
3 of 3