Configuring Ipx Interfaces - Avaya P580 User Manual

CLI Commands

Configuring IPX Interfaces

Web Agent
Procedure
Document No. 650-100-700, Issue 1
Table 16-2. IPX Routing Global Configuration Dialog Box
Parameters
Parameter Allows you to...
SAP Select Disable to prevent IPX SAP from routing globally.
This affects all IPX interfaces set up to use the IPX SAP
routing protocol. The default value is Enable.
Maximum Enter the maximum number of routes that can be added to
Number of the routing table. The switch rounds your entry to the
Routes nearest power of 2. For example, if you enter 1000, the
system rounds this number up to 1024 routes. The default
value is 2048.
Maximum Enter the maximum number of services that can be added.
Number of The switch rounds your entry to the nearest power of 2. For
Services example, if you enter 1000, the system rounds this number
up to 1024 services. The default value is 2048.
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
To enable IPX routing globally using the CLI, enter the following command
from Configure mode:
(configure)# ipx routing
To enable IPX routing Globally
<configure> no ipx routing
To disable IPX routing Globally
You can create new IPX interfaces and configure up to four interfaces of
different encapsulation types to a VLAN (multinetting). You can configure
an IPX interface using either the Web Agent or the CLI.
To create a new IPX interface using the Web Agent:
1. Select Interfaces from Routing > IPX > Configuration group on the
Web Agent window. The IPX Interfaces dialog box opens
Configuring IPX Routing
2 of 2
(Figure 16-5).
16-5