Deleting Ospf Virtual Links - Avaya P580 User Manual

Chapter 15
CLI Command

Deleting OSPF Virtual Links

Web Agent
Procedure
15-14
Table 15-4. Add OSPF Virtual Link Dialog Box Parameters
Parameter Defines the...
Dead Interval Time in seconds that a router's Hello packets have not
been seen before it's neighbors declare the router down.
This should be some multiple of the Hello interval. This
value must be the same for all routers attached to a
common network.The value range is 1-65535. The default
is 40.
Authentication Type of authentication available for use on a given OSPF
interface. Authentication types include:
Authentication Authentication key for the Area.
Key
MD5 Key ID MD5 authentication key ID as a decimal value. The
values range is 1-255.
4. Click CREATE to create the virtual link, or CANCEL if you do not
want to create the OSPF virtual link.
To create a OSPF virtual link, use the following command:
(configure router: ospf)# area <area-id> virtual-link
<router-id>
You can delete OSPF Virtual links using either the Web Agent or the CLI.
To delete an OSPF virtual link using the Web Agent:
1. Select Virtual Links from the Routing > IP > OSPF group on the Web
Agent window. The OSPF Virtual Links dialog box opens
5).
2. Select the virtual link that you want to remove.
3. Click DELETE. The virtual link is removed.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
• None (default)
• Simple Password
• MD5 Authentication
2 of 2
(Figure 15-