CLI Command
Adding Static Entries to the AFT
Web Agent
Procedure
Document No. 650-100-700, Issue 1
To search the switch AFT using the CLI, enter the following command in
Configure mode:
(configure)# show aft entry
You can add static entries to the AFT manually using the Web Agent or the
CLI.
To add an AFT address manually using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Address
Forwarding Table folders, and then click Address Configuration.
The Static Address Configuration Web page is displayed in the content
pane. See
Figure
9-6.
Figure 9-6. Static Address Configuration Web Page
2. In the MAC Address field, enter the MAC address that you want to add
to the table.
Managing the Address Forwarding Table
9-19