Avaya P580 User Manual page 443

CLI Command
Document No. 650-100-700, Issue 1
Table 14-2. RIP Interface Dialog Box Parameters
Parameter Allows you to...
Default Route Specify the mode for the default route learning on this
interface. Different states include:
Disable is the default setting.
Auth Type Specify the type of authentication available for use on a
given RIP interface. Authentication types include:
None is the default setting
Auth Key If Auth Type is:
None is the default setting.
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
To modify RIP interfaces parameters using the CLI enter the following
command from Configure mode:
(configure)# interface <intf-name> | [type {mbna |
ethernet}]
• Disable - Disables the default route.
• Talk Only - Send RIP information to the network.
• Listen Only - Receive RIP information from the
network.
• Talk/Listen - Both send and receive RIP information
from the network.
• None - No authentication required.
• Simple - Uses a clear-text password for validation.
This password is sent unencrypted across the network
to neighboring RIP routers.Available for RIP V2 only.
• MD5 - Uses an encrypted Key to validate RIP V2
routing updates from neighboring RIP V2 routers.
• None - leave this field blank, or this field is ignored.
• Simple - Enter the clear-text password for validating
RIP packets from neighbor RIP V2 routers.(1-16
characters)
• MD5 - Enter the defined Key Chain values under
Routing > IP > RIP > Key Chains.
Configuring RIP Routing
2 of 2
14-5