GBIC Identification
Web Agent
Procedure
CLI Command
Document No. 650-100-700, Issue 1
The GBIC Identification feature identifies the type of GBICs that are
installed in 80-series gigabit modules with GBIC interfaces. The feature
identifies the following types of connectors:
GBIC SX (short wavelength)
GBIC LX (long wavelength)
GBIC LX/LH (long wavelength/long haul)
If any nonstandard connectors are present, the feature identifies them as
GBIC LX/LH. You can view this information by using the Web Agent, CLI,
or SNMP.
To use the Web Agent to view the type of GBICs that are connected to the
modules in your switch, open the Physical Port Configuration Web page.
The type of GBIC that is connected to each port is displayed in the
Connector field on this Web page.
To open the Physical Port Configuration Web page:
1. Expand the Modules & Ports folders.
2.
Click Configuration.
The Module Information Web page opens.
3.
In the Ports column, click the number for the module that you want to
view GBIC types for.
The Physical Port Configuration Web page opens
Gigabit modules and
To use the CLI to view the type of GBICs that are connected to the modules
in your switch:
1. Enter either the User, Privileged, or Global Configuration mode.
2. Enter the following command:
show port physical [{<mod-num> | <mod-swport-range>} [...,{<mod-
num> | <mod-swport-range>}]]
The type of GBIC that is connected to each port is displayed in the
Connector field.
Figure 8-7
for 10/100 modules).
Configuring Ports
(Figure 8-5
for
8-47