Avaya P580 User Manual page 615

CLI Command
Document No. 650-100-700, Issue 1
Figure 21-7. Syslog Configuration Web Page
3. In the Enable State field, select Enable or Disable:
Enable—Enables syslog reporting to the IP addresses that you enter
in the Syslog Collector's IP Addresses fields.
Disable—Disables syslog reporting. Syslog is disabled by default.
4. In the Syslog Collector's IP Addresses fields, enter the IP addresses of
the remote syslog servers. You can specify a maximum of three syslog
servers.
5. In the Severity field, select a severity level. See
information about each severity level. The default setting for this field is
error.
The switch logs error messages of the severity that you select and of all
higher severities.
6. Click Apply.
Use the following CLI commands to configure syslog event reporting:
To enable or disable syslog event reporting, (configure)# set
syslog {enable | disable}
To configure which events are logged, (configure)# set syslog
facility {start | system | config | temp | resource | fan |
service_port | user _port | power | bridge_stat | switch_fabric |
ospf | rip | ldap | appletalk | auth_failure | redundant_cpu |
dvmrp | cli | snmp | unknown_mac | vrrp | login_status | acl_log
| ssl_ssh | all}
Monitoring the Avaya Multiservice Switch
Table 21-6 for more
21-15