Avaya P580 User Manual page 307

Multiservice switches

Hide thumbs Also See for P580:

Table of Contents

Document No. 650-100-700, Issue 1

5. Click SYNCHRONIZE to start the synchronization process.

If both supervisors are running v6.0 or later application software, the

switch performs the following checks after you synchronize the active

and standby supervisors:

Version of application software.

Startup image (app 1, app 2, cardapp 1, or cardapp 2)

If any of these settings changed during the synchronization, the standby

supervisor module automatically resets so that it is failover-ready. In

earlier versions of software, you had to manually reset the standby

supervisor, if these settings changed.

* Important: If you are updating the boot code, you must

manually reset the standby supervisor after

synchronizing it with the active supervisor.

* Note: For this automatic reset feature to work, the active and standby

supervisors must both be running v6.0 or later application

software. The first time that you synchronize the supervisor

modules after upgrading the active supervisor to v6.0 from an

earlier version of software, you must manually reset the

standby supervisor.

To synchronize the active and standby supervisor modules, use the

following CLI command:

(configure)# cpu_redundancy synchronize

Configuring Redundancy Options