Chapter 10 - Configuring Rip Routing; Overview; Configuring Rip On The Switch - Avaya Cajun P882 User Manual

10

Overview

Configuring RIP on the Switch

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide,v5.3.1
Configuring RIP Routing
* Note: To globally enable the Routing Information Protocol
(RIP), refer to Chapter 9, "Configuring IP Routing".
The information and procedures provided in this chapter pertain to
50 series layer 3, and licensed 80 series module configurations only:
This section describes:
Configuring RIP on the Switch
Modifying RIP Interfaces
Creating Trusted RIP Neighbors
Viewing RIP Statistics
Key Chains
NBMA IP Interfaces
You can configure RIP from either the Web Agent or the CLI.
* Note: MD5 authentication in the 5.X versions of switch
software is not compatible with MD5 authentication in
earlier versions of the software.
If you enable MD5 authentication on a switch that is
running 5.X software and on a switch that is running
4.X software, the switches do not exchange routing
information.
10-1