Avaya P580 User Manual page 188

Chapter 6
CLI Command
6-30
Table 6-4. VTP Snooping Parameters
Parameter
Updater Identity
Update Timestamp
9. Click APPLY to save your changes, or CANCEL to restore previous
settings.
To configure VTP snooping using the CLI, enter the following command in
Configure mode:
(configure)# set vtp-snooping enable
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Definition
Displays the IP address of the Cisco switch that
initiated the VTP configuration update.
Displays the date and time that the Cisco switch
initiated the VTP configuration update. The
format of the timestamp is "yy/mm/
dd.hh:mm:ss", where yy/mm/dd represents the
year, month, and day and hh:mm:ss represents the
hours, minutes, and seconds.
2 of 2