Avaya P580 User Manual page 513

Document No. 650-100-700, Issue 1
Table 17-2. Add IPX RIP Filters Dialog Box Parameters
Parameter
Direction
Filter/Suppress
Ticks
Hops
4. Click APPLY to save your changes, or CANCEL to restore previous
settings.
Configuring the IPX RIP Protocol
Allows you to...
Select the direction of the filter from a pull-down menu.
The pull-down filter menu options are:
• Inbound - Apply the filter only to RIP packets
received on the interface.
• Outbound - Apply the filter only to RIP packets
sent on the interface.
• Both - Apply the filter to RIP packets both sent
and received on the interface.
• The default is Outbound
Disable the IPX networks (within the specified range in
the filter) to be filtered (inbound) or suppressed
(outbound).
• Filtered - Apply the filter only to RIP packets
received (inbound direction) on the interface.
• Suppressed - Apply the filter only to RIP packets
sent (outbound direction) on the interface.
Enable allows you to filter and suppress traffic and is
the default. Select Disable to disable the filtering and
suppression of traffic.The default is Enable
Specify the time (in ticks) that the packet takes to reach
the network number you specified. A tick is
approximately 1/18th of a second. This entry is used to
override the value in the RIP packet.
If you enter 0, there will be no override in the
transmission of data on the network.The default is o
Specify the number of routers (hops) that the packet
must pass through before reaching the network number
associated with the IPX interface. This entry is used to
override the value in the RIP packet.
If you enter 0, there will be no override in the
transmission of data on the network. The default is 0
2 of 2
17-5