CLI Command
Modifying OSPF Virtual Links
Web Agent
Procedure
CLI Command
Creating OSPF Summaries
Web Agent
Procedure
Document No. 650-100-700, Issue 1
To delete an OSPF virtual link, use the following command:
(configure router: ospf)# [no] area <area-id> virtual-link
<router-id>
You can modify OSPF virtual links using either the Web Agent or the CLI.
To modify an OSPF virtual link using the Web Agent:
1. Select Virtual Links from the Routing > IP > OSPF group on the Web
Agent window. The OSPF Virtual Links dialog box opens
5).
2. Select the virtual link that you want to modify.
3. See
Table 15-4
to modify the OSPF Virtual Links dialog box
parameters.
4. Click APPLY to save your changes, or CANCEL to restore previous
settings.
To modify an OSPF virtual link, use the following command:
(configure router: ospf)# area <area-id> virtual-link
<router-id> [hello-interval <seconds>] [retransmit-interval <seconds>]
[dead-interval <seconds>] [{authentication-key <key> | message-digest-
key <key-id> md5 <key>}]
The primary purpose of the OSPF summary is route aggregation. Route
aggregation is a group range of IP addresses that are linked to a single
address.
You can create a new OSPF summary from either the Web Agent or the
CLI.
To create a new OSPF summary using the Web Agent:
1. Select Summaries from the Routing > IP > OSPF group on the Web
Agent window,. The OSPF Summaries dialog box opens
Configuring the OSPF Routing Protocol
(Figure
(Figure 15-
15-7).
15-15