CLI Commands
Modifying RIP Interfaces
Web Agent
Procedure
Document No. 650-100-700, Issue 1
Table 14-1. RIP Global Configuration Dialog Box Parameters
Parameter
Allows you to...
Triggered
Disable or Enable route updates that were triggered by a
Updates
topology change in the network to be added to the routing
table. The default is Enable.
Update Pkt
Enter the value (in seconds) that represents the time delay
Delay
between successive RIP update packets to the neighbor, when
the update requires multiple packets. The default value is 1
second. The parameter range setting is 0-50 seconds.
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
To configure or modify the RIP parameters globally on your switch using
the CLI, enter the following commands in router:rip mode:
(configure router:rip)# timers basic <update>
<invalid> Update Timer <Msec>
<Range:Min=10,Max=50>
(configure router:rip)# output-delay <delay>
(configure router:rip)# triggered updates <CR>
<enable,disable>
You can modify RIP interfaces from either the Web Agent or the CLI.
To modify RIP interfaces using the CLI from the Web Agent:
1. Select Interfaces from the Routing > IP > RIP group on the Web Agent
window. The RIP Interfaces dialog box opens
Figure 14-2. RIP Interfaces Dialog Box
Configuring RIP Routing
2 of 2
(Figure
14-2).
14-3