Resetting The Standby Supervisor - Avaya P580 User Manual

CLI Command

Resetting the Standby Supervisor

Web Agent
Procedure
Document No. 650-100-700, Issue 1
Figure A-4. System Reset Web Page
3. Select Yes in response to the question, Do you want to reset the switch?
The switch resets and loads the new application software.
To reset the switch after downloading new application software, use the
following CLI command:
(configure)# reset
The previous procedure,
Active Supervisor to Standby mode and the Standby Supervisor to the
Active Supervisor mode. To recover back to the original state, with both
supervisors running new code, reset the current Active supervisor module.
To reset the Active Supervisor to the Standby Supervisor:
1. In the navigation pane, expand the System folder.
2. Select System Reset.
The System Reset Web page is displayed in the content pane
4).
3. Select Yes in response to the question, Do you want to reset the switch?
Upgrading the Application Software
"Resetting the Active Supervisor," forces the
(Figure A-
A-9