Modifying a DVMRP Interface
Web Agent
Procedure
Document No. 650-100-700, Issue 1
You can modify a DVMRP interface using either the Web Agent or the CLI.
To modify a DMVRP interface using the Web Agent:
1. Select Interfaces from the Routing > DVMRP group of the Web Agent
window. The DVMRP Interfaces dialog box opens (see
Figure 12-19. DVMRP Interfaces Dialog Box
* Note: You must first set "multicast protocol" on an interface to
DVMRP before you can configure DVMRP. See
Existing IP
Interfaces," earlier in this chapter, and enable a
multicast protocol for this interface.
2. See
Table 12-10
to complete your DVMRP configuration:
Table 12-10. DVMRP Interface Parameters
Parameter
Select
Interface
IP Address
IP Address Mask
Defines the...
Select a DVMRP interface that you want to configure.
Displays the Interface that is configured with the
DVMRP multicast protocol.
Displays the IP address of each interface. You cannot
modify this field.
Displays the Subnet mask for each interface. You
cannot modify this field.
Configuring IP Routing
Figure
12-19).
"Displaying
1 of 2
12-41