Web Agent
Procedure
CLI Command
Creating a VRRP Virtual Router
Web Agent
Procedure
Document No. 650-100-700, Issue 1
To enable an VRRP on an interface using the Web Agent:
1. Select Interfaces from the Routing > IP > Configuration group on the
Web Agent window. The IP Interfaces dialog box opens
37).
Figure 12-37. IP Interface Dialog Box
2. Select the interface on which you want VRRP to be enabled.
3. Select Enable from the VRRP field pull-down menu for the interface
you selected.
4. Click APPLY to save your changes, or CANCEL to restore previous
settings.
To enable an VRRP on an interface using the CLI, enter the following
command in Configure/Interface mode:
(config-if: <if name> )# ip vrrp
You can create a VRRP router using either the Web Agent or the CLI.
To create a VRRP router from the Web Agent:
1. Select VRRP from the Routing > IP > Configuration group on the Web
Agent window. The VRRP Virtual Routers dialog box opens
(Figure
12-38).
Configuring IP Routing
(Figure 12-
12-77