Editing an AppleTalk NBP Filter
Web Agent
Procedure
CLI Command
Document No. 650-100-700, Issue 1
You can edit an AppleTalk NBP filter using either the Web Agent or the
CLI.
To edit an AppleTalk NBP filter using the Web Agent:
1. Select NBP Filter from the Routing > AppleTalk > Configuration
group on the Web Agent window. The AppleTalk NBP Filter dialog
box opens
(Figure
19-15).
Figure 19-15. AppleTalk NBP Filter
2. See
Table 19-3
to edit the AppleTalk NBP Filter dialog box parameters.
3. Click:
CREATE to add a new filter. The Add AppleTalk NBP Filter
—
dialog box opens. See
Protocol (NBP)
information.
DELETE to remove the selected NBP filter.
—
CANCEL to restore previous settings.
—
Edit If to add or delete this NBP filter to/from an interface. The
—
Add/Delete Interface to NBP Filter dialog box opens. See
"Adding or Deleting Interfaces to an NBP
chapter for more information.
To edit an AppleTalk NBP filter using the CLI, enter the following
command in Interface mode:
(config-if:<interface-name>)# appletalk access-
list <access-list-number> <permit | deny> nbp
<string>
Configuring AppleTalk Routing
"Creating an AppleTalk Name-Binding
Filter" earlier in this chapter for more
Filter" later in this
19-17