Avaya P580 User Manual page 536

Chapter 19
19-6
4. See Table 19-1 to configure the Add AppleTalk Interface dialog box
parameters:
Table 19-1. Add AppleTalk Interface Dialog Box Parameters
Parameter Definition
Interface Enter the name of the AppleTalk interface to be created. 1
to 32 Characters
VLAN Select the VLAN to be associated with the AppleTalk
interface.
Metric Enter the metric associated with the AppleTalk interface.
Encapsulation Select the encapsulation type to be associated with the
Type AppleTalk interface.The options include:
Network Range Enter the starting network number. The network number
Start specifies the range of AppleTalk network numbers for
extended networks. Each number in the range must be an
integer between 0 and 65279.
Note:
Network Range Enter the ending network number. The network number
End specifies the range of AppleTalk network numbers for
extended networks. Each number in the range must be an
integer between 0 and 65279.
Note:
Network Enter the interface network number. This number specifies
Number the network number the interface is using.
Note:
Node Enter the interface node identification number. This
number must be between 1 and 253.
Note:
Admin State Select whether to enable or disable the administrator state.
The administrator state determines if the interface is
operational from a management point of view.
Zone Select the default AppleTalk zone to be used by this
interface. Zone names may be up to 32 characters in length.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
• Ethernet II - MTU = 1500
• Ethernet SNAP - MTU =1492
The Network Range Start value must be less than
or equal to the Network Range End value.
If the Network Range Start value equals 0, then the
Network Range End value must also equal 0.
This value must be within the Network Range or
be equal to 0.
Only if the Network Number is equal to 0, can the
Node also be equal to 0.