Avaya P580 User Manual page 180

Chapter 6
Adding Switch
Ports to the Hunt
Group
6-22
Figure 6-12. Physical Port Configuration Window
3. Uncheck the checkbox from the Enable column for a specific port. The
check mark disappears to disable the port.
* Note: Check the speed of the ports that you are configuring into the
Hunt Group. The ports must be physically connected to each
other (for example, in a four-port Gigabit hunt group, ensure
that you have four fiber cables with switch ports connected at
each end).Also Auto-negotiation should be disabled on the
ports to further ensure against speed mismatch
If this is a new hunt group, disable all of the ports you are
—
adding to the hunt group.
If you are adding ports to an existing hunt group, disable the
—
ports you are adding.
4. Click APPLY to save your changes, or CANCEL to restore previous
settings.
1. Select Modules at the bottom of the Physical Port Configuration
dialog box. The Module Information dialog box
As an alternate procedure, select Modules & Ports > Configuration.
2. Select a number from the Switch Ports column, for the module whose
port(s) you are adding to the hunt group. The Switch Ports dialog box
opens (Figure 6-13).
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
re-opens.(Figure 6-11).