CLI Command
Deleting a Port Redundancy Pair
Web Agent
Procedure
CLI Command
Document No. 650-100-700, Issue 1
4. Complete the following:
Name—Enter the pair's name.
Primary Port—Select the pair's primary port from the pull-down
menu.
Secondary Port—Select the pair's secondary port from the pull-
down menu.
5. Click Apply.
To create a port redundancy pair, use the following CLI command:
(configure)# set port-redundancy name <redundant-name>
{<primary-port>} {<secondary-port> | huntgroup <secondary-
huntgroup-name>}
You can delete a port redundancy pair from the Port Redundancy
Configuration web page.
To delete a port redundancy pair:
1. In the navigation pane, expand the L2 Switching folder.
2. Click Port Redundancy. The Port Redundancy Configuration web page
appears.
3. Select the redundancy pair(s) you want to delete.
4. Click Delete.
The redundancy pair is deleted.
To delete a port redundancy pair with the CLI, use the following command
in Configure mode:
(configure)# no port-redundancy <pair-name>
Configuring Ports
8-45