Configuring Rip Timeout Interval - Avaya 5000 Series Troubleshooting Manual
Ethernet routing switch
Hide thumbs
Also See for 5000 Series:
- Installation manual (101 pages) ,
- Installing (84 pages) ,
- Manual (64 pages)
Table of Contents
Advertisement
Figure 89: RIP routes are learned-deleted learned again
Configuring RIP timeout interval
About this task
You must configure the timeout interval on the device where the RIP route is cycling so that it
is the same or larger than the update interval on the peer device.
Task flow: Configure RIP timeout interval
You can use the following task flow to help ensure that the timeout and update intervals are
correctly configured.
Troubleshooting
RIP routes are learned then deleted and relearned
December 2013
187
Advertisement
Table of Contents
Troubleshooting
