CLI Commands
Editing AppleTalk Interfaces
Web Agent
Procedure
Document No. 650-100-700, Issue 1
5. Click Apply to add the new AppleTalk interface, or CANCEL to restore
previous settings. Once you click Apply, you are returned to the
AppleTalk Interfaces dialog box
Figure 19-4. AppleTalk Interfaces
Use the following CLI commands in interface mode to create an AppleTalk
interface:
(config-if:<interface-name>)# appletalk cable-range <cable-
range>
(config-if:<interface-name>)# appletalk address <network.node>
(config-if:<interface-name>)# appletalk zone <zone-name>
(config-if:<interface-name>)# appletalk vlan <vlan-id>
You can edit AppleTalk interfaces using either the Web Agent or the CLI.
To edit an AppleTalk interface using the Web Agent:
* Note: You must enable AppleTalk globally and create an AppleTalk
interface before you can edit an interface. See
AppleTalk Global
Routing
Interface" earlier in this chapter.
1. Select Interfaces from the Routing > AppleTalk > Configuration
group on the Web Agent window. The AppleTalk Interfaces dialog box
opens
(Figure
19-6).
2. If there is no zone to select or if you want to edit the zones available,
complete this step through step x. If not, skip to step x+1. Select Edit
Zone to edit the AppleTalk zone for this interface. The Edit AppleTalk
Zone dialog box opens
Configuring AppleTalk Routing
(Figure
19-4.)
Routing" and
"Creating an AppleTalk
(Figure
19-5).
"Enabling
19-7