Avaya P580 User Manual page 492

Chapter 16
16-10
2. To create a new IPX Static Route Click on CREATE
* Note: Only the create button is shown if no IPX Static Routes are
configured.
3. The Add IPX Static Route dialog box opens (see
Figure 16-7. Add IPX Static Route Dialog Box
4. See Table 16-4 to configure the IPX Static Route parameters.
Table 16-4. IPX Static Route Parameters
Parameter Allows you to...
Network Enter the IPX network number that you want to assign to
the IPX static route.
Next-Hop Node Enter the MAC address for the next destination to which
the packet is routed. Format of the value to enter is
aa:bb:cc:dd:ee:ff.
Interface View the IPX Interface associated with the next hop.
Ticks Enter the amount of time (in ticks) that the packet takes to
reach the network number you specified. A tick is
approximately 1/18th of a second.
Hops Enter the number of routers (hops) that the packet must
pass through before reaching the network number
associated with the IPX network.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Figure 16-7).