Chapter 7
CLI Commands
7-24
6. Click APPLY to save your changes or CANCEL to restore the previous
settings.
For information about all other switch port settings, see
Switch Ports
Settings" in
Use the following CLI commands to configure Spanning Tree settings for a
switch port:
To enable or disable Spanning Tree on a port, (configure)#
set port spanning-tree-mode {<mod-num> | <mod-swport-
range>} [...,{<mod-num> | <mod-swport-range>}] {disable |
enable}
To specify whether a port is connected to a shared LAN segment or
a point-to-point LAN segment, (configure)# set port point-
to-point admin status {<mod-num> | <mod-swport-range>}
[...,{<mod-num> | <mod-swport-range>}] {force-true | force-false
| auto}
To specify whether this port is an edge port or a nonedge port,
(configure)# set port edge admin state <mod-swport-
range> [...,<mod-swport-range>] {edge-port | non-edge-port}
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Chapter
8,
"Configuring
"Configuring
Ports."