Management Port; Static Ip Entry For The Oob Network Management Interface - Avaya 8800 Commissioning Manual

Table 5: Secure and nonsecure protocols for IPv4
Nonsecure protocols
FTP and TFTP
Telnet
SNMPv1, SNMPv2
Rlogin
HTTP

Management port

You must assign an IP address to the management port before you can use it for out-of-band
(OOB) management. In a switch with redundant 8692 with super mezz or 8895 modules, each
management port uses a specific IP address. In addition, you can create a virtual management
port with an IP address available to the master management module.
The master management module replies to all management requests sent to the virtual IP
address, and to requests sent to the management port IP address. If the master management
module fails and the backup management module takes over, the virtual management port IP
address continues to provide management access to the switch.

Static IP entry for the OOB network management interface

The following figure shows the OOB network management port default IP assignment.
Commissioning
Default Equivalent secure protocols
status
Disabled SCP
Disabled Secure SHell (SSH) v1, v2
Avaya recommends that you use
SSHv2 instead of SSHv1.
Enabled SNMPv3
You must load the DES/AES image
on the switch to use SNMPv3.
Disabled Secure SHell (SSH) v1, v2
Disabled No equivalent
Important:
Avaya recommends that you do
not use this protocol due to the
risk to the security of your
network.
Management port
Default
status
Disabled
Disabled
Enabled
Disabled
June 2011 19