Modifying A Dvmrp Interface - Avaya Cajun P882 User Manual

Modifying a DVMRP Interface

Modifying the
DVMRP
Interface Using
the Web Agent
Parameter
Select
Interface
IP Address
IP Address Mask
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
You can modify a DVMRP interface using either the Web Agent or
the CLI.
To modify a DMVRP interface using the Web Agent:
1. Select Interfaces from the Routing > DVMRP group of the
Web Agent window. The DVMRP Interfaces dialog box
opens (see Figure 9-20).
Figure 9-20. DVMRP Interfaces Dialog Box
* Note: You must first set "multicast protocol" on an interface to
DVMRP before you can configure DVMRP. Refer to
"Displaying Existing IP Interfaces", earlier in this chapter,
and enable a multicast protocol for this interface.
2. Refer to Table 9-9 to complete your DVMRP configuration:
Table 9-9. DVMRP Interface Parameters
Defines the...
Select a DVMRP interface that you want to configure.
Displays the Interface that is configured with the
DVMRP multicast protocol.
Displays the IP address of each interface. You cannot
modify this field.
Displays the Subnet mask for each interface. You
cannot modify this field.
Configuring IP Routing
1 of 2
9-57