H3C S3610-28P Operation Manual page 1500

Operation Manual – RRPP
H3C S3610&S5510 Series Ethernet Switches
Figure 1-8 Networking diagram for single-domain intersecting rings configuration
II. Configuration considerations
First, determine the primary ring and subring in an RRPP domain, node mode of a
device on each RRPP ring, and then perform the following configuration on a
per-device basis:
Create an RRPP domain.
Specify the control VLAN for the RRPP domain.
Specify the node mode of a device on an RRPP ring and the ports accessing the
RRPP ring on the device.
Enable these two RRPP rings.
Enable RRPP
III. Configuration procedure
1) Perform the following configuration on Device A:
<Device A> system-view
[Device A] rrpp domain 1
[Device A-rrpp-domain1] control-vlan 4092
[Device A-rrpp-domain1] ring 1 node-mode master primary-port ethernet 1/0/1
secondary-port ethernet 1/0/2 level 0
[Device A-rrpp-domain1] ring 1 enable
[Device A-rrpp-domain1] quit
[Device A] rrpp enable
2) Perform the following configuration on Device B:
<Device B> system-view
[Device B] rrpp domain 1
[Device B-rrpp-domain1] control-vlan 4092
1-21
Chapter 1 RRPP Configuration