Enabling Dldp; Setting Dldp Mode; Setting The Interval For Sending Advertisement Packets - H3C S3610-28P Operation Manual

Operation Manual – DLDP
H3C S3610&S5510 Series Ethernet Switches

1.2.1 Enabling DLDP

Follow these steps to enable DLDP:
To do...
Enter system view
Enable DLDP
globally
Enter
Ethernet
port
view or
port
group
view
Enable DLDP
Caution:
DLDP takes effect only when it is enabled both globally and on a port.

1.2.2 Setting DLDP Mode

Follow these steps to set DLDP mode:
To do...
Enter system view
Set DLDP mode

1.2.3 Setting the Interval for Sending Advertisement Packets

You can set the interval for sending Advertisement packets to enable unidirectional
links to be detected in time.
Use the command...
system-view
dldp enable
Enter
Ethernet
interface interface-type
port interface-number
view
Enter
port-group { aggregation
port
agg-id | manual
group
port-group-name }
view
dldp enable
Use the command...
system-view
dldp work-mode { enhance |
normal }
1-11
Chapter 1 DLDP Configuration
Remarks
—
Required
Globally disabled by default
Either of the two is required.
The configuration performed
in Ethernet port view applies
to the current port only. The
configuration performed in
port group view applies to all
the ports in the port group.
Required
Disabled on a port by default
You can perform this
operation on an optical port
or an electrical port.
Remarks
—
Optional
Normal by default